歡迎來到專業從事合肥裝修建材批發銷售裝飾裝潢公司合肥裝修建材網!
更多>>聯係我們
地址:合肥市五裏廟建材市場
您的位置 >> 首頁 > 裝修百科 裝修百科

合肥裝修建材網淺談水電安裝注意事項有哪些

來源:合肥裝修建材網   瀏覽:11   【字體: 】 發布日期: 2017-8-24 16:59:20 打印

對水電安裝的重要性是不言而喻的。它不僅關係到將來的生活方便,而且關係到主機的安全,尤其是電路的安裝。讓我們先來看看電路的安裝說明:

合肥裝修建材網淺談水電安裝注意事項有哪些-裝修百科

所有的電氣控製線路和接線必須通過PVC管穿。如果有在天花板沒有樹蔭有減力牆,線從牆上。同一條管線敷設在同一根管道上,管線尺寸合適,通過管道的數量應通過管道橫截麵積不超過PVC管橫截麵積的40%。


線不能彎曲超過90度,超過90度的連接管。電線必須分開時,他們都磨破了,他們都是通過管磨損。連接牢固可靠,絕緣良好(電阻大於0.5m)。合理線路布置。的開關和插座固定位置必須符合要求,即,開關離地麵1200-1300mm和出口300-450mm離地麵。線條清晰有序。40平方米以上的室內麵積,空調線路應鋪設4平方毫米BV銅芯。


以上我們了解安裝電路的注意事項,那麽在安裝水路時注意些什麽呢?下麵我們就來了解它。
所有關節牢固、可靠、密封性好。出水管應冷熱,冷熱左右。室內隱蔽管道必須加壓才能關閉。一般在工作壓力不大於0.6mpa前提下,不合格現象是減壓。


水龍頭和管件接頭不得外露。在出口管的延長線應垂直於牆。在防水的過程中,整體防水防水,一般要求布三油,或兩布六油(十字補片)。塗膜防水層必須平整、均勻,無脫皮、殼、裂紋、氣泡等缺陷。不漏水24小時防水工程檢驗方法合格。


The importance of installation of water and electricity is self-evident. It is not only related to the convenience of life in the future, but also related to the safety of the host, especially the installation of the circuit. Let us first look at the notes of the installation of the circuit:
All electrical control lines and wiring must be worn through PVC tubes. If there is no shade at the ceiling and there is a force reduction wall, the line goes from the wall. The same circuit wire should be laid in the same pipe, the line size is appropriate, and the number of pipe through should be done through the pipeline cross-sectional area of not more than 40% of the cross sectional area of PVC pipe.
The wire must not bend more than 90 degrees and be connected to the pipe by more than 90 degrees. The wires must be separated from each other when they are worn through, and they are all worn through the tube. The connection is firm and reliable and the insulation is good (resistance is greater than 0.5M). Reasonable line layout. The fixed position of the switch and socket must comply with the requirement, that is, the switch is off the ground 1200-1300MM and the outlet is 300-450MM away from the ground. The lines are clear and orderly. Indoor area of 40 square meters or more, air-conditioning lines should be laid 4 square millimeters BV copper core.
The above we understand the installation of the circuit notes, then what are the points of attention when we install the waterway? Here we come to understand it.
All joints are firm, reliable and well sealed. The water outlet pipe should be cold hot, cold hot right left. Indoor concealed pipes must be pressurized before they are closed. Generally in the work pressure is not greater than 0.6MPA premise, without decompression phenomenon is qualified.
The joint of faucet and pipe fittings shall not be exposed. The extension line on the outlet pipe shall be perpendicular to the wall. In the waterproof process, the overall cast-in-place waterproof, generally requires a cloth three oil, or two cloth six oil (cross patch). Coating waterproof layer must be smooth, uniform, no peeling, shell, cracks, bubble and other defects. Waterproof engineering inspection method for 24 hours without water leakage is qualified.



合肥裝修建材官方網站:http://www.gsrtnh.com
最新內容:
  • 書房風水布局禁忌和臥室門風水禁忌
  • 淺談餐廳風水財位方位和客廳風水擺設
  • 裝修房子風水注意事項之玄關的各種注意
  • 裝修房子風水之屋頂傾斜度太大和樓梯與門直衝
  • 洗漱台安裝注意事項和不同類型的窗簾的清洗方法
  • 淺談生態門的優缺點和布藝的搭配裝飾
  • 淺談集成吊頂選購方法和窗簾羅馬杆的優缺點
  • 窗簾滑軌安裝優缺點和如何選擇集成吊頂
  • 如何規避家具潛在隱患?臥室地毯什麽材質好?
  • 客廳沙發顏色怎麽選?購買家具需要注意什麽?
  • 關於我們
    • 關於我們
    聯係我們
    地址:合肥市五裏廟建材市場
    版權所有:合肥裝修建材銷售網